Air Compressor Specifications
| Pressure | 9-12 / 130-174 bar |
|---|---|
| Lubrication | ISO VG#15 |
Troubleshooting
4Fault codes
| Code | Meaning | Cause | Remedy |
|---|---|---|---|
| A | The hydraulic piston is not rising up with or without load | 1. Not enough air pressure supply to the jack 2. hydraulic piston is missing oil 3. Failure of the pneumatic pump | 1.a Supply air pressure within the tolerances specify into the manual and on the product nameplate 1.b Confirm the pneumatic hoses are correctly connected to the tie-ins (Fig.02) 2.a fill-in tank with recommended hydraulic oil (ISO VG#15) 2.b failure of the hydraulic system, product to be repair by authorized repair center 3. Product to be repaired by authorized repair facility |
| B | The hydraulic piston is not reaching the maximum position | Hydraulic piston is missing oil | Fill-in tank with recommended hydraulic oil (ISO VG#15) |
| C | The hydraulic piston cannot stand in upper position | 1. hydraulic piston is leaking oil. 2. Failure of the pneumatic pump | 1. Check the product to detect potential oil leakage from the piston. Send the product to authorized repair facility for reparation 2. Product to be repaired by authorized repair facility |
| D | The hydraulic piston is not going down | 1. Not enough air pressure supply to the jack 2. Failure of the pneumatic pump 3. Air leakage from the dustproof gasket | 1.a Supply air pressure within the tolerances specify into the manual and on the product nameplate 1.b Confirm the pneumatic hoses are correctly connected to the tie-ins (Fig.02) 2.&3. Product to be repaired by authorized repair facility |
Fault codes and symptom→remedy steps extracted from this unit’s service/owner documentation; verify against the official manual before servicing.
Available documents
Operator's manual
About
Chicago Pneumatic ATJ30-2 — air compressor. Specifications and parts compiled from manufacturer documents.