Air Compressor Specifications
| Lubrication | Each time a Series 2925B2Ti Impactool is disassembled for maintenance and repair or replacement of parts, lubricate the tool as follows: 1. Work approximately 12 to 15 cc of Ingersoll Rand No. 170 Grease into the impact mechanism. Coat the Anvil (40) lightly with grease around the Hammer Case Bushing (42). Inject approximately 2 to 4 cc of grease into the Grease Fitting (18). 2. Use Ingersoll Rand No. 10 Oil for lubricating the motor. Inject approximately 1 to 2 cc of oil into the air inlet before attaching the air hose. |
|---|
Troubleshooting
4Symptoms & remedies
| Symptom | Cause | Remedy |
|---|---|---|
| Low power | Dirty Inlet Bushing or Inlet Screen and/or Muffler | Using a suitable cleaning solution, in a well ventilated area, clean Inlet Screen, Inlet Bushing and Muffler. |
| Worn or broken Vanes | Replace complete set of Vanes. | |
| Worn or broken Cylinder and/or scored End Plates | Examine Cylinder and replace it if it is worn or broken or if bore is scored or wavy. Replace End Plates if they are scored. | |
| Dirty motor parts | Disassemble tool and clean all parts with a suitable cleaning solution, in |
Fault codes and symptom→remedy steps extracted from this unit’s service/owner documentation; verify against the official manual before servicing.
Available documents
Service manual
About
Ingersoll Rand 2925RB2Ti — air compressor. Specifications and parts compiled from manufacturer documents.