Air Compressor Specifications
| Lubrication | Each time a Series 2925P1Ti and 2925P3Ti Impactool is disassembled for maintenance and repair or replacement of parts, lubricate the tool as follows: 1. Work approximately 12 to 15 cc of Ingersoll Rand No. 170 Grease into the impact mechanism. Coat the Anvil (40, 42 or 48) lightly with grease around the Hammer Case Bushing (38). Inject approximately 2 to 4 cc of grease into the Grease Fitting (17). 2. Use Ingersoll Rand No. 50 Oil for lubricating the motor. Inject approximately 1 to 2 cc of oil into the air inlet before attaching the air hose. |
|---|
Troubleshooting
2Symptoms & remedies
| Symptom | Cause | Remedy |
|---|---|---|
| Low power | Dirty Inlet Bushing or Air Strainer Screen and/or Exhaust Silencer | Using a suitable cleaning solution, in a well ventilated area, clean Air Strainer Screen, Inlet Bushing and Exhaust Silencer. |
| Motor will not run | Improper positioning of the Reverse Valve Lever or Reverse Valve | Make certain that the Reverse Valve Lever is in the reverse position or one of the three forward positions. If the tool has been disassembled, refer to Dw |
Fault codes and symptom→remedy steps extracted from this unit’s service/owner documentation; verify against the official manual before servicing.
Available documents
Service manual
About
Ingersoll Rand 2925Ti — air compressor. Specifications and parts compiled from manufacturer documents.