Pump Specifications
| Self-priming | true |
|---|
Troubleshooting
16Symptoms & remedies
| Symptom | Cause | Remedy |
|---|---|---|
| Cannot pull or hard to pull recoil starter | Debris caught in impeller | Dismantle & clean impeller |
| Low or reduced water flow | Debris caught in suction hose | Dismantle & clean hose |
| Air leakage on suction side | Check suction hose and side suction connections | |
| Engine not performing | Check & repair engine see John Deere dealer | |
| Damage to mechanical seal | Replace mechanical seal see John Deere dealer | |
| Suction lift is too high | Make suction lift lower | |
| Suction hose is too long or smaller in diameter | Shorten suction hose or enlarge diameter | |
| Leakage of water from discharge hose | Stop leakage of water | |
| Worn out impeller | Replace the impeller see John Deere dealer | |
| Pump does not prime | Air goes in from suction side | Check hose and suction connections (See Solution 2) |
| Insufficient priming water | Pour more water into pump casing for priming | |
| Drain plug is loose | Tighten drain plug firmly. | |
| Damage of mechanical seal | Replace mechanical seal see John Deere dealer | |
| Wrong suction hose used | Use correct suction hose | |
| Water leakage between engine and pump | Damaged mechanical seal | Replace see John Deere dealer. |
| Engine does not start | Refer to engine manual see John Deere dealer |
Fault codes and symptom→remedy steps extracted from this unit’s service/owner documentation; verify against the official manual before servicing.
Available documents
Operator's manual
About
John Deere CC-TP3GH — pump. Specifications and parts compiled from manufacturer documents.