Transfer Switch Specifications
| Rated current | 225 A |
|---|---|
| Voltage | 120 V |
| Phase | 1 |
| Transition | Open |
Troubleshooting
1| Symptom | Cause | Remedy |
|---|---|---|
| the demonstration unit does not operate as expected | Check the power connection and verify that the power switch is in the ON position. Press the Lamp Test button and verify that all LEDs illuminate. If no LEDs illuminate, disconnect power and check the fuse. The unit uses a 5 amp, 250 V, slo-blo, 5 x 20 mm fuse. Press and hold the Lamp Test button until the LEDs flash to reset the controller. Use the Setup Program to check that the source parameters match the factory settings shown in Figure 2. Check other settings including time delays and voltage pickup and dropout settings. Check the event history for a list of the most recent controller events. Disconnect power and check the ATS DIP switch settings. Verify that the Maintenance DIP switch is OFF and the other DIP switches are set to the appropriate positions for your demonstration. Disconnect power and check the connections. Refer to the wiring diagrams in the following section. |
Symptom → cause → remedy extracted from this unit’s service/owner documentation; verify against the official manual before servicing.
About
Kohler GM29836-KP1 — transfer switch. Specifications and parts compiled from manufacturer documents.